CWS Door Installation Nationwide | Sightline Windows & Doors Doral

CWS Door Installation: The Doral Owner’s Guide

CWS door installation in Doral typically runs $1,800-$4,200 for a standard replacement, depending on the series and whether the opening needs reframing. We stock CWS-compatible hardware and seals on our trucks, and most residential swaps in Doral are completed in a single day once the measured survey is approved. Most homeowners discover a CWS door is failing when the sweep drags, the multipoint lock won’t throw fully, or they feel air movement around the jamb during a summer storm - all signs that the installation, not just the door, has shifted out of tolerance.

Call (786) 460-1563

Which CWS Models This Applies To

CWS manufactures several door lines common in Doral homes built between 2015 and 2022: the CWS 3750 and CWS 5400 series for single-family entrances, and the CWS Impact Entry line for homes in wind-borne debris zones. The label is usually stamped into the hinge jamb or printed on a sticker behind the strike plate - look for a six-digit model prefix followed by the door size and swing code.

The critical compatibility gotcha in South Florida: CWS changed its multipoint lock footprint between the 2018 and 2020 production years. The bolt spacing shifted from 85mm to 92mm on the 5400 series, which means a lock ordered by series name alone may not seat without mortise modification. We carry both patterns and verify with a physical template before cutting.

We are an independent service provider - not affiliated with CWS - and we source both OEM CWS hardware and verified aftermarket equivalents from suppliers who meet the same Miami-Dade HVHZ testing standards. For most Doral homes, the aftermarket multipoint and hinge sets we stock perform identically at roughly 30% lower parts cost, though we default to OEM when the original lock mechanism is still under CWS’s 10-year component warranty.

Signs Your CWS Door Installation Is Failing

• The door sticks at the top corner in summer, then gaps in winter. This is the classic symptom of a frame that was shimmed without accounting for Doral’s concrete-slab settlement patterns. The CWS composite jamb doesn’t warp, but the rough opening does - and the installation, not the door, has lost its plumb.
• Water pools on the interior sill after a hard rain. The CWS sill pan and end-seal gaskets are designed for a specific slope tolerance. If the installer set the sill dead level instead of pitching it 1/8 inch toward the exterior, water backs up. In Doral’s afternoon deluges, that shows up fast.
• The multipoint lock handle turns but the bolts don’t engage. Usually a misalignment between the lock faceplate and the keepers in the jamb. The CWS 5400’s three-point system has zero tolerance for shift - even 2mm of frame movement and the middle bolt misses its pocket entirely.
• You see daylight between the weatherstrip and the door edge. Compression seals on CWS doors are replaceable, but repeated slamming or UV exposure in unshaded south-facing entries hardens the bulb. Once the seal loses memory, air infiltration follows - and your AC bill in Doral’s eight-month cooling season reflects it.
• The door rattles in the frame during wind gusts. This means the hinge screws have backed out of the jamb or the strike plate has elongated its mortise. On CWS impact-rated doors, this is a security issue as much as a comfort one - the door can’t resist design pressure if it isn’t fully seated.

Before

After

Replacement Cost & What’s Included

What drives the range: the condition of the rough opening, whether the existing frame can be reused, and whether the wall is block or wood frame. Every quote we write in Doral begins with a measured survey you keep - the same document becomes the scope of work, and the price on that page is the price on the invoice. Haven Clause 1. No change orders for conditions we should have caught at survey.

The 365-Day Done Right Promise covers the installation and any hardware we supply. If the lock won’t throw or the seal won’t seal, we return and make it right - documented with photos, same as the original visit.

DIY or Call Us?

There’s a short list of things a CWS owner can safely check: the strike plate screws (tighten with a manual screwdriver, not a drill), the threshold screws, and whether debris is blocking the sill track. Beyond that, the risks stack up.

CWS impact-rated doors weigh 90-140 pounds depending on size and glazing. Removing one without proper support risks frame distortion, glass stress cracks, or personal injury. The multipoint lock mortise requires a router template specific to the CWS bolt spacing - freehand cutting voids the warranty and usually destroys the jamb. And if your home is in a Miami-Dade HVHZ zone, any modification to an impact-rated assembly requires re-certification; an unpermitted DIY install can complicate your windstorm insurance.

We don’t upsell what doesn’t need doing. If your CWS door just needs a reset and new seals, we’ll say so - and we’ll write that price before any work starts. Call (786) 460-1563 to schedule your free estimate.

FAQs